Engine
Net Power - SAE J1349
Engine Model
Engine Power - ISO 14396:2002
Gross Power - SAE J1995:2014
Rated Speed
Peak Power Speed
Emissions
U.S. EPA Tier 4 Final, EU Stage V, and Japan 2014
Bore
Stroke
Displacement
Peak Torque - 1,200 rpm - SAE J1995
Torque Rise
Operating Specifications
Operating Weight
Operating Weight - Standard
Operating Weight - High Lift
Rated Payload - Standard (Quarry Face)
Rated Payload - Loose Material (Standard)
Bucket Capacity Range
Transmission
Transmission Type
Cat switched reluctance electric drive
Forward 1 (virtual)
Forward 2 (virtual)
Forward 3 (virtual)
Forward 4 (virtual)
Reverse 1 (virtual)
Reverse 2 (virtual)
Reverse 3 (virtual)
Hydraulic System - Lift/Tilt
Lift/Tilt System - Circuit
EH-Positive Flow Control, Flow Sharing
Lift/Tilt System - Pump
Variable displacement piston
Maximum Flow at 1,400-1,600 rpm
Relief Valve Setting - Lift/Tilt
Lift Cylinder - Bore
Lift Cylinder - Stroke
Tilt Cylinder - Bore
Tilt Cylinder - Stroke
Hydraulic Cycle Times
Rack Back
Raise
Dump
Lower Float Down
Total Hydraulic Cycle Time
Hydraulic System - Steering
Steering System - Circuit
Steering System - Pump
Piston, variable displacement
Maximum Flow at 1,400-1,600 rpm
Steering Cut Off Pressure
Total Steering Angle
Steering Cycle Times - High Idle
Steering Cycle Times - Low Idle
Air Conditioning System
Air Conditioning
The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equivalent of 2.574 metric tonnes.
Axles
Front
Rear
Oscillation Angle
Brakes
Brakes
Operator's Cab
ROPS/FOPS
ROPS/FOPS meet ISO 3471:2008 and ISO 3449:2005 Level II standards
Service Refill Capacities
Fuel Tank
Cooling System - Jacket Water
Cooling Systems - Power Train
Engine Crankcase
Diesel Exhaust Fluid Tank
Transmission
Differential - Final Drives - Front
Differential - Final Drives - Rear
Hydraulic System - Implement/Steering
Note
All nonroad Tier 4 Final/Stage V diesel engines are required to use: – The machine has the flexibility to run on either ultra-low-sulfur diesel fuel (ULSD with 15 ppm of sulfur or less). – Cat engines are compatible with the following renewable, alternative, and biodiesel* fuels that reduce greenhouse gases: Up to B20 biodiesel (FAME) ** Up to 100% HVO and GTL renewable fuels * Refer to guidelines for successful application. Please consult your Cat dealer or “Caterpillar Machine Fluids Recommendations” (SEBU6250) for details. – Cat DEO-ULS™ or oils that meet the Cat ECF-3, API CJ-4, and ACEA E9 specifications are required. – Only use DEF that meets ISO 22241-1 standards.
Sound Performance - Tier 4 Final / Stage V - Standard
Operator Sound Pressure Level (ISO 6396:2008)
Machine Sound Power Level (ISO 6395:2008)
Sound Performance - Tier 3 / Stage III - Standard
Operator Sound Pressure Level (ISO 6396:2008)
Machine Sound Power Level (ISO 6395:2008)
Dimensions (Approximate) - Standard Lift
Ground to Top of ROPS
Ground to Top of Exhaust Stacks
Ground to Top of Hood
Ground to Bumper Clearance
Rear Axle - Centerline to Bumper
Front Axle Centerline to Bucket Tip
Wheel Base
Maximum Overall Length
Ground to Lower Hitch Clearance
Ground to Center of Axles
Clearance at Maximum Lift
B-Pin Height - Maximum Lift
Maximum Overall Height - Bucket Raised
Reach - Maximum Lift
Note
Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height.
Dimensions (Approximate) - High Lift
Ground to Top of ROPS
Ground to Top of Exhaust Stacks
Ground to Top of Hood
Ground to Bumper Clearance
Rear Axle - Centerline to Bumper
Front Axle Centerline to Bucket Tip
Wheel Base
Maximum Overall Length
Ground to Lower Hitch Clearance
Ground to Center of Axles
Clearance at Maximum Lift
B-Pin Height - Maximum Lift
Maximum Overall Height - Bucket Raised
Reach - Maximum Lift
Note
Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height.
Dimensions - Millyard Linkage
Ground to Top of ROPS
Ground to Top of Exhaust Stacks
Ground to Top of Hood
Ground to Bumper Clearance
Rear Axle - Centerline to Bumper
Front Axle Centerline to Fork Tip
Wheel Base
Maximum Overall Length
Ground to Lower Hitch Clearance
Ground to Center of Front Axle
Fork Height with Level Arms
Fork Top Clamp Opening
Fork Height at Maximum Lift
Hinge Pin Height at Maximum Lift
Dump Angle at Maximum Lift
Buckets
Bucket Capacities
Sustainability
Recyclability