Engine
Engine Model
Rated Speed
Peak Power Speed
Engine Power - ISO 14396
Gross Power - SAE J1995
Net Power - SAE J1349
Emissions
U.S. EPA Tier 4 Final, EU Stage V, and Japan 2014
Bore
Stroke
Displacement
Peak Torque - 1,200 rpm - SAE J1995
Torque Rise
Operating Specifications
Operating Weight
Rated Payload - Quarry Face
Bucket Capacity Range
Cat Truck Match - High Lift
Transmission
Transmission Type
Cat planetary power shift
Forward - 1
Forward - 2
Reverse - 1
Reverse - 2
Direct Drive - Forward 1
Direct Drive - Forward 2
Direct Drive - Forward 3
Direct Drive - Forward 4
Direct Drive - Reverse 2
Direct Drive - Reverse 3
Direct Drive - Reverse 4
Hydraulic System - Lift/Tilt
Lift/Tilt System - Circuit
Lift/Tilt System
2X x 145 cc Variable displacement piston
Maximum Flow at 2,165 rpm
Relief Valve Setting - Lift/Tilt
Cylinders, Double Acting - Lift, Bore and Stroke
190 mm x 1216 mm (7.5 in x 48 in)
Cylinders, Double Acting - Tilt, Bore and Stroke
170 mm x 722 mm (6.7 in x 28.4 in)
Pilot System
Variable displacement piston
Tilt Cylinder - Stroke
Hydraulic Cycle Times
Rack Back
Raise
Dump
Lower Float Down
Total Hydraulic Cycle Time - Empty Bucket
Hydraulic System - Steering
Steering System - Circuit
Steering System - Pump
Piston, variable displacement
Maximum Flow
Relief Valve Setting - Steering
Total Steering Angle
Steering Cycle Times - High Idle
Steering Cycle Times - Low Idle
Air Conditioning System
Air Conditioning
The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equivalent of 2.574 metric tonnes.
Axles
Front
Rear
Oscillation Angle
Brakes
Brakes
Operator's Cab
ROPS/FOPS
ROPS/FOPS meet ISO 3471:2008 and ISO 3449:2005 Level II standards
Service Refill Capacities
Fuel Tank
Cooling System
Engine Crankcase
Diesel Exhaust Fluid Tank
Transmission
Differential - Final Drives - Front
Differential - Final Drives - Rear
Note
Cat U.S. EPA Tier 4 Final, EU Stage V, and Japan 2014 diesel engines are required to use ULSD (ultra-low sulfur diesel fuel with 15 ppm of sulfur or less) or ULSD blended with the following lower-carbon intensity fuels up to: - 20% biodiesel FAME (fatty acid methyl ester)* - 100% renewable diesel, HVO (hydrotreated vegetable oil) and GTL (gas-to-liquid) fuels. Refer to guidelines for successful application. Please consult your Cat dealer or “Caterpillar Machine Fluids Recommendations” (SEBU6250) for details. *Engines with no aftertreatment devices can use higher blends, up to 100% biodiesel. **For use of blends higher than 20% biodiesel, consult your Cat dealer
Sound Performance - Tier 4 Final/EU Stage V - Standard
Operator Sound Level (ISO 6396)
Machine Sound Level (ISO 6395)
Note (1)
The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Note (2)
Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.
Note (3)
The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Dimensions (Approximate) - High Lift
Ground to Top of ROPS
Ground to Top of Exhaust Stacks
Ground to Top of Hood
Rear Axle - Centerline to Bumper
Front Axle Centerline to Bucket Tip
Wheel Base
Maximum Overall Length
Ground to Lower Hitch Clearance
Clearance at Maximum Lift
B-Pin Height - Maximum Lift
Maximum Overall Height - Bucket Raised
Reach - Maximum Lift
Note
Specifications are calculated with 6.9 m3 (9.0 yd3 ) rock bucket equipped with Michelin XLDD1 35/65 R33 tires.
Buckets
Bucket Capacities
Sustainability
Recyclability
Transmission
Direct Drive - Reverse 1