Engine
Engine Model
Net Power
Bore
Stroke
Displacement
Rated Speed
Emissions
U.S. EPA Tier 4 Final/EU Stage IV, Tier 3 Equivalent, or Tier 2 Equivalent
Torque Rise
Net - SAE J1349
Peak Power Speed
Peak Torque - 1,300 rpm
Gross - SAE J1349
Transmission
Direct Drive - Reverse 3
Forward - 3
Direct Drive - Reverse 1
Forward - 2
Direct Drive - Forward 2
Forward - 1
Direct Drive - Reverse 2
Reverse - 2
Direct Drive - Forward 3
Reverse - 1
Reverse - 3
Forward - 4
Direct Drive - Forward 1
Direct Drive - Forward 4
Transmission Type
Cat planetary power shift
Brakes
Brakes
Axles
Front
Rear
Oscillation Angle
Weights
Operating Weight
Service Refill Capacities
Cooling System
Crankcase
Transmission
Hydraulic System - Tank Only
Differential - Final Drives - Rear
Differential - Final Drives - Front
Hydraulic System Factory Fill
Diesel Exhaust Fluid Tank*
Fuel Tank
Operating Specifications
Coal Scoop Operating Weight
Chip Scoop Operating Weight
Sound Performance - Tier 4 Final/Stage IV: Suppression
Operator Sound Level (ISO 6396)
Machine Sound Level (ISO 6395)
Sound Performance - Tier 4 Final/Stage IV - Standard
Operator Sound Level (ISO 6396)
Machine Sound Level (ISO 6395)
Dimensions (Approximate)
Height - Top of Exhaust Stack
Centerline of Front Axle to Hitch
Length - With Chip Scoop on Ground
Ground to Center of Front Axle
Length - With Coal Scoop on Ground
Height - Top of Cab
Length - Front of Tire
Centerline of Rear Axle to Edge of Bumper
Height - Top of Air Cleaner
Height - Top of Hood
Ground Clearance
Wheel Base
Scoops
Coal Scoop Carry Capacity
Hydraulic System - Lift/Dump/Tilt
Pilot Maximum Flow
Pilot Relief Valve Setting
Maximum Flow at 1,900 rpm
Lift/Tilt System
Variable displacement piston
Cylinders, Double Acting - Left and Right Dump, Bore and Stroke
127 mm × 838 mm (5.0 in × 33.0 in)
Lift/Tilt System - Circuit
Pilot operated LS valve with EH
Relief Valve Setting - Lift/Tilt
Cylinders, Double Acting - Lift, Bore and Stroke
170.0 mm × 1107 mm (6.7 in × 43.6 in)
Pilot System
Variable displacement piston
Hydraulic System - Steering
Maximum Flow
Total Steering Angle
Steering Cycle Times - Low Idle
Steering Cycle Times - High Idle
Relief Valve Setting - Steering
Steering System - Pump
Piston, variable displacement
Steering System - Circuit
Service Refill Capacities
Note (1)
All non-road Tier 4 Final/Stage IV Technology diesel engines are required to use:
– Ultra Low Sulfur Diesel (ULSD) fuels containing 15 ppm (mg/kg) sulfur or less. Biodiesel blends up to B20 are acceptable when blended with 15 ppm (mg/kg) sulfur or less ULSD and when the biodiesel feedstock meets ASTM D7467 specifications.
– Cat DEO-ULS™ or oils that meet the Cat ECF-3, API CJ-4, and ACEA E9 specifications are required.
Sound Performance - Tier 4 Final/Stage IV: Suppression
Note (1)
The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008.
– The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Scoops
Type
Large capacity scoops for both wood chip and coal applications. A mesh screen integrated into the back of the scoop maintains visibility to the cutting edge. The chip scoop version has extra screens at the top due to higher capacity.
Components
Both scoops come with dual lift cylinders for increased lift capacity. Integrated stabilizer system makes sure that the scoop stays stable and centralized on the machine. Scoop tilt function is standard and provides ±15 degrees of tilt to maintain grade conditions and keep your operation safe.
Coal Scoop Doze Capacity
Sound Performance - Tier 2 Equivalent/Stage II: Standard
Note (1)
The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. – The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Transmission
Note
Travel speeds based on 35/65-R33 tire.
Sound Performance - Tier 2 Equivalent/Stage II: Suppression
Note (1)
The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. – The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Note (2)
Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.
Sound Performance - Tier 2 Equivalent/Stage II: Standard
Machine Sound Level (ISO 6395)
Sound Performance - Tier 2 Equivalent/Stage II: Suppression
Machine Sound Level (ISO 6395)
Sound Performance - Tier 2 Equivalent/Stage II: Standard
Operator Sound Level (ISO 6396)
Dimensions (Approximate)
Height - Edge of Dumped Scoop
Height - Edge of Retracted Scoop
Sound Performance - Tier 4 Final/Stage IV - Standard
Note (2)
Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.
Sound Performance - Tier 2 Equivalent/Stage II: Suppression
Operator Sound Level (ISO 6396)
Sound Performance - Tier 2 Equivalent/Stage II: Standard
Note (3)
The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008.
– The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Hydraulic System - Lift/Dump/Tilt
Cylinders, Double Acting - Tilt, Bore and Stroke
152.4 mm × 953 mm (6.0 in × 37.5 in)
Sound Performance - Tier 4 Final/Stage IV - Standard
Note (1)
The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. – The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Service Refill Capacities
Note (2)
*Only applicable to Tier 4 Final/Stage IV equipped machines.
Scoops
Chip Scoop Carry Capacity
Sound Performance - Tier 2 Equivalent/Stage II: Suppression
Note (3)
The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. – The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Scoops
Chip Scoop Doze Capacity
Sound Performance - Tier 4 Final/Stage IV: Suppression
Note (2)
Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.
Sound Performance - Tier 4 Final/Stage IV - Standard
Note (3)
The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. – The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Dimensions (Approximate)
Dump Angle at Full Lift Height
Sound Performance - Tier 4 Final/Stage IV: Suppression
Note (3)
The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. – The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Air Conditioning System
Air Conditioning
The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equivalent of 2.574 metric tonnes.
Sound Performance - Tier 2 Equivalent/Stage II: Standard
Note (2)
Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.